Add PSRAM detection and size verification support for Shrike-fi hardware testing.

[GaikwadPrasad]

What does this PR do?

Adds support for the Shrike-Fi board to test GPIO functionality, PSRAM detection, and PSRAM size verification as part of the full hardware test.

Type of change

• Firmware improvement(Added PSRAM support for testing)
• Add Images Folder (verify the Output with or without PSRAM)
• Documentation update

Board(s) tested on

• Shrike-fi (ESP32-S3)

Checklist

For all PRs:

• I have tested my changes
• My code follows the project's style guidelines
• I have updated relevant documentation

[dpks2003]

Hello what's the difference between this and #69 ?

The title is misleading please rewrite it i think its full hardware test for hardware right.

[GaikwadPrasad]

The title is misleading please rewrite it i think its full hardware test for hardware right.

Yes. I will change the title, It is for full hardware test with psram.

[GaikwadPrasad]

@dpks2003 I have updated changes. Please check.

[dpks2003]

sure

[dpks2003]

in the output logs can you add logs like

:PSRAM Detected
PSRAM Verified Successfully
or PSRAM Failed

: FPGA Programmed

something similar in the end so test do not have to read through the complete serial logs

[dpks2003]

flash_test.sh
is mentioned however i don't see that in PR

[dpks2003]

Also all the setup steps can you create a setup.sh file for that easier for the tester to setup

[GaikwadPrasad]

flash_test.sh is mentioned however i don't see that in PR

In this file has nothing any change.

[GaikwadPrasad]

in the output logs can you add logs like

:PSRAM Detected PSRAM Verified Successfully or PSRAM Failed

: FPGA Programmed

something similar in the end so test do not have to read through the complete serial logs

I already have added logs in the program file and also mentions the output log screenshot in the Image folder.

[dpks2003]

The PR is approved will be merged after Testing onces