WILCS02 Linux v3.0

The following are key enhancements and bug fixes in WILCS02 Linux Release v3.0:

New Features:

• WFA Certified
• Wi-Fi / BLE Co-existence
• Regulatory Domain Support
• WILC/WILCS02 unified driver on Kernel v6.6

Fixes:

• Fixed WFA Certification issues
• Fixed 802.11 power-save not handling the QoS null frames
• Fixed AP Mode to extract the HT, WMM IEs
• Fixed the A-MSDU packet corruption in Rx path
• Improved the Tx-Struck algorithm
• Improved Performance
• Fixed SAMA5D27 SPI throughput issues
• Fixed SoftAP PMF issues

WILCS02 Linux v2.0

New Features:

• SDIO-SPI Mode support Over MMC-SPI
• Firmware Sideloading over bus interface
• 802.11 Power Save Mode
• Calibration Algorithm v2.2
• Strap-pin handling to support SDIO 4 Bit/SPI Mode selection
• Regulatory Domain - Statically configured via gain table programming in the firmware
• Improved TPC alogorithm
• Enhanced logging with software watchdog reset support

Fixes:

• Fixed SoftAP WPA connection issue
• Fixed Fast alarm trigger issues
• Fixed STA/SoftAP connectivity in high traffic environment
• Fixed MAC HW PRNG is not seeded
• Fixed the Scan overlap/timer/results issues
• Fixed STA responding to spoofed frames under a PMF connection
• Fixed the "unicast Deauth/Dissoc frames" issues
• Fixed the shared-packet fairness algorithm
• Fixed the Auto-rate algorithm issues

WILC Linux 16.3

• For wilc1000, fixed the transmission issue of the large data blocks
• WILC/WILCSO2 Unified driver codebase
• Synchronize linux4Microchip & mainline patches
• Supports kernel v6.6

WILC Linux 16.2

Updated sama5d27_som1_ek demo for release 16.2

Signed-off-by: Ajay Singh <[email protected]>

WILC Linux 16.1

Changes since release 16.0:

• Ported WILC 1000/3000 driver on Linux kernel 6.1
• Fix interoperability BlockAck QOS frame Ack failure with specific AP
• Fix memory leak in Linux host driver when the hostapd is killed in AP mode

WILC Linux 16.0

Key feature changes from previous WILC 15.7 release

• WILC1000 WFA Re-certified
• Fix WFA FlexTrack and QuickTrack testcase scenarios for MPF and IGTK installation

WILC Linux 15.7

Changes since release 15.6:

The following are the bug fixes for ATWILC Linux Release v15.7

1. Migrated WILC 1000/3000 Wi-Fi driver to Linux Kernel 5.15
2. Moved compiled time legacy kernel featurization to patch
3. Fixed crash issue observed in the AP mode with latest cfg80211 'netdev' register API
4. Fixed possible memory corruption when VMM size is more than 64 KBytes for only WILC3000
5. Fixed interoperability WPS issue based on config request

WILC Linux 15.6

Changes since release 15.5:

The following are the new features in ATWILC Linux Release v15.6

1. WPA3 Support (WILC1000 only)

The following are the bug fixes for ATWILC Linux release v15.6

1. Fix deprecated WEP on WILC1000/3000
2. Fix 11b RF Carrier Suppression on WILC1000
3. Fix a crash issue in the WILC driver while VMM transfer entries exceed (supported) 64 slots.
4. Fix FragAttack vulnerability issues(refer release notes for more details)

WILC Linux 15.5

Changes since release 15.4.1:

Bug Fixes:

Fix Command(crc7) and Data(crc16) CRC check enabling on WILC SPI bus
Fix WILC AP mode hang-up issue
Fix WILC1000: Specific AP's are not getting detected during the scan
Fix WILC3000 SPI: Sometimes bus communication error observed during PS mode
Fix WILC3000 BLE fails to start advertising under some application command sequence
Fix WILC1000 SPI: Fix TXQ starvation issue
Fix Default GPIO's values are not getting populated
Fix WILC SPI failure recovery mechanism issue
Fix Gain table settings for WILC1000 and WILC3000 UA

WILC Linux 15.4.1

Changes since release 15.4:

Bug Fixes:

1. Fix network packet flow in WILC 1000/3000 WiFi Driver
2. Fix HIF instability issues in WILC 3000 - In PSM mode due to DC-DC trim values
3. Fix HIF instability issues in WILC 3000 - In WiFi-BLE co-existence
4. Fix Memory leak in WILC driver scan while connect/disconnect AP
5. Fix WiFi Driver for SDIO suspend/resume
6. Fix WILC 1000 SPI communication stall issues