μPython code for small robot

Configuration

Copy config.py.example to config.py, then (re-)flash the robot (see below).

Flashing setup

In a Python 3 virtual env, do:

$ python -m pip install esptool adafruit-ampy requests click
$ pip install adafruit-ampy

Then, run python flash-me.py mqtt to flash the robot.

This uploads both firmware and Python modules. If the firmware is successfully flashed, then on subsequent flash-me.py you can pass -X to only update the Python modules.

Diagnostics (MQTT)

• robot moves both wheels after successfull connection to WiFi

• otherwise open terminal and connect to the board

hardware needed

• NodeMCU board with ESP8266

• DOIT Motor shield for NodeMCU (guide)

• Two DC motors with wheels

• lunch box

HOW TO: connect to terminal

• Open terminal (Putty, Picocom, Minicom or whatever). speed: 115200

• Press Ctrl+C to stop running Python code. Prompt >>> should appear.

Links

Web joystick for MQTT is available at https://github.com/lbartok/mqtt-robot-webdriver/

This project is a fork from: VerosK