Releases: atwilc3000/driver
Releases · atwilc3000/driver
11.3
Fix the followings:
- SoftAP channel 1 is not shown
- ifconfig down fails
- cannot assign IPV6 address in case of SoftAP mode
- AP WEP security is broken
- Power consumption performance
- bluez - music gliches during BT scan
- somtimes BT turned off and on automatically
- higher baudrate issue with bluez
11.2.4
Fix the followings:
- Support built-in
11.02
Fix the followings:
- Turning BT and Wifi at the same time fails
- AP WEP security is broken
- Deauthentication frame received from access point onsuspend/resume
- Apply 11b transceiver settings
- Investigate Audio Glitches during BT scan
- Sometimes BT audio glitches occur while streaming audio on BT and streaming data on WiFi
- Failure in pairing from NMC3000 (bluedroid) to iphone mobile
11.0
- Add fix for IPv6 Support
- remove dead codes
- remove unused preprocessor definition
- define undefined operation mode
- Use Host’s default SDIO speed
- Control Chip_En and ResetN using GPIOs
11.01
- Driver source code was not update, only update firmware 11.01v
- Fix that some boards fail find APs while scanning
10.0.1
10.0
Fix the followings:
- Tx autorate sometimes decreases and never picks up
- Apply RF settings to enhance PER
- Optimize the size of program memory
- Add UART bus access support to WILC3000 GUI
9.0
Fix the followings:
- Sync with linux mainline version of the driver
- PMU enters POC when turning Wifi ON after toggling Wifi or BT ON/OFF
- Memory crapper in firmware due to out-of-range access of static array
- Add mac address filtering feature to packet statistics
8.0
Fix the followings:
- Use one FW for both STA and AP mode.
- Memory corruption caused by TCP ack filter algorithm
- Transmit Power Control
- Set Global mode control from BT FW
7.0
Fix the followings:
- Operate with one firmware image for station mode and P2P mode
- Use 2nd MAC Interface
- Synchronize IC's interrupt enable with 3000's Interrupts
- Switching Wifi ON fails if BT is in powersave