The official Micron BOM is here.
If you want to purchase full kits there are 3 available (Kits are slowly updating to R1 hardware just make sure to double check the included hardware in your kit and if you have any questions reach out in the discord)
Formbot Micron+ (180x180) Kit (Affiliate Link)
Funssor Micron (120x120) Kit (Affiliate Link)
Formbot Micron+ (180x180) Kit (Aliexpress Affiliate Link)
120x120 build
| Misumi Part # | Qty | Notes |
|---|---|---|
| HFS3-1515-300 | 4 | Blind holes need to be drilled |
| HFS3-1515-220 | 10 | Ends need to be tapped (M3) |
| HFS3-1515-205 | 2 | |
| HFS3-1515-190 | 1 | |
| HFS3-1515-120 | 1 |
| Part | Qty | Length | Notes |
|---|---|---|---|
| MGN7H | 6 | 160mm | will work with V0 150mm rails if wanted, but 160mm will work as well and is recommended |
| MGN9C OR MGN9H | 1 | 160mm | will work V0 150mm rails but 160 will work as well and is recommended |
180x180 build
| Misumi Part # | Qty | Notes |
|---|---|---|
| HFS3-1515-350 | 4 | Blind holes need to be drilled |
| HFS3-1515-280 | 10 | Ends need to be tapped (M3) |
| HFS3-1515-265 | 2 | |
| HFS3-1515-250 | 1 | |
| HFS3-1515-180 | 1 |
| Part | Qty | Length |
|---|---|---|
| MGN7H | 6 | 220mm |
| MGN9C OR MGN9H | 1 | 220mm |
There are 2 versions of this mod, 1 from Zruncho and the other from a user named Zen3D. Both of them have their uses. I prefer to use the Zen3D kind just for the fact that the screw can go all the way through the printed part. Zrunchos do have a much nicer fitment into the extrusions but they also dont allow the screw to go all the way through.
Thanks to the following people on Discord who have helped make this printer what it is today.
- @KyleGB - too many additions to name them all
- @TheWarolf#1247
- @L.e.o.p.a.r.d#0990
- @deepfriedheroin#5006
- @JosAr#0517
- @sentein#3903
- @madcat#7838
- @Kyrios#5486
- @faithblinded#1491
- @zruncho#1790
- @Finn#2449
- @clee#1337
- @slidr#4412
- @gfunnymoney#3748
- Jason from LDO
- Voron Dev Team
- all the R1 beta testers
