1. Introduction
This project was born to upgrading cheap and basic HK-T6A or FS-CT6B transmitter.
These transmitters don't have display and offer a configuration through a serial port
with an external PC software program
also not space to store more than one model.
| FS-CT6B | HK-T6A | |
|---|---|---|
 |
 |
 |
- Low power consumption (2S LiOn/LiPo battery)
- 3 buttons for settings
- Stable 6 Channel PPM generation
- 5 memory for storing model data
- 2 gimbal stick + 2 pots support
- Throttle Cut switch
- Dual Rates switch
- Normal Reverse channels settings
- Dual Rates settings (Low, High)
- Battery monitor
- SPI OLED display 128x64 support
- Analog input ports with possible high ADC sampling used
- All possible digital input/output pins used
- 3 digital buttons input for menu (original code are analog input)
- Switch checking status with sound alert at power ON
and display which is not in default position - Throttle warning with display status of switches and sound alert
- Hidden data default restoring by pressing and hold Down/Next button on power on
- Hidden calibration procedure by pressing and hold Enter/Select button on power on
- Real time battery control whith alarm sound (buzzer with stand alone sound generator)
- N°2 supplementary switch, they can be configured instead of VRA or VRB pots (SWA, SWB)
(Servo Direction Menu) - Basic two channel mixer with switch activation V-Mix (Ch1/ch2)
- Basic four channels Sub Trim setting (ch1, ch2, ch3, ch4) with real time PPM monitor