With Full_Workflow, the texture quality is too poor, how could I improve it?

[Justnormalguy]

I used the default configuration in the Full_Workflow, but it looks like so bad, And I don't know how to fix it, more steps or more guidance_scale don't seem to work. By the way, I run it in the newest ComfyUI.
The Input and output are as follows:

[ELiZswe]

Part of the issue in the above example is the rug.
If you add a remove background to the image, it will produce a better result(Assuming that you don't want the carpet

But I do think you identified an scenario where the multiview is not trained to produce that type of geometry as simple as a cube. Or it's the warped perspective a 45 degree like that produces the issue.
At least I'm not good enough to get a clearer result other the example above on the cube it self.

For me Hunyuan really shines at model creation, the multiview generation, and then the following inpaint never produced "pefect" result for me. Example is the double nipple paintjob that it does here:

But since I'm going to retexure it normally I'm ok with it not being perfect.