-
Notifications
You must be signed in to change notification settings - Fork 47
Home
MMeowlink lets OpenAPS connect to Medtronic pumps without using the CareLink stick.
- MMeowlink gives us better range than the CareLink can provide. Our experience is that the device can cover a reasonably sized room when placed centrally.
- When placed a under a bed, there are no missing gaps in overnight OpenAPS coverage. You no longer need two CareLink sticks for coverage.
- Unlike the CareLink stick, the MMCommander sticks can be used with the Intel Edison. This allows us to replace the Raspberry Pi with the much smaller and lower power-consumption Edison.
- TI USB sticks, running MMCommander with write-enabled firmware
- CC1110 devices, running the subg_rfspy firmware
- Wireless Things ERF
- Wireless Things Slice of Radio (Note that this is currently untested, but will be confirmed shortly) -- Rileylink (note at the moment this is wired in, rather than over bluetooth)
If you're new to OpenAPS, it's really probably best to stick with the Carelink stick to start. All of these options require quite a lot of fiddling around with electronics, firmware, and some are quite likely to even involve a soldering iron.
If you're based near other OpenAPS users that have gone through this process before, they may well be able to give you a hand. They may also be able to save you expensive purchases. Some of the items are only used once during this process. You should reach out on the https://gitter.im/oskarpearson/mmeowlink?utm_source=badge&utm_medium=badge&utm_campaign=pr-badge&utm_content=badge chat group or on the OpenAPS mailing list for help. Some users may have modules with pre-built firmware available that they can send your way, which would dramatically reduce the complexity of this process.
In all of the below cases, you want additional range, and are willing to trade range for some complex setup. There are a variety of cost options and size options that you can choose from.
Recommended when:
- You have a TI/mmcommander stick, or someone that can help you install mmcommander on one
- You don't want to solder things
- You want to reduce the size of your rig by using an Intel Edison (the carelink doesn't work with the Edison)
This is probably the easiest to get going with. TI-USB-Stick to see how this would work.
## Option 2: Edison with ERF radio
Recommended when:
- You want the smallest possible setup
- You are willing to pay for an Intel Edison (it costs a lot more than a Pi, and a lot lot more than a Pi zero)
- You want to reduce battery size as much as possible
- You're willing to go through the complexity of installing an alternative Operating System on the Edison
- You're willing to solder things
This is the closest we've got to an 'ideal' physical solution, but it takes a lot of work to reduce the size. It may be worth starting with one of the simpler and lower-cost options first. This will reduce the size from option 1 (Pi or Edison with TI cc1111 stick) by about 50% - but at probably 10x the complexity.
NOTE Nobody's doing this yet - but Oskar is going to fill this bit of the wiki soon.
Recommended when:
- You want something that's reasonably low cost - and if it gets dropped in a puddle or crushed it won't break the bank
- You want something small, but don't necessarily want all the complexity of the Edison setup
- Are probably ok soldering 4 wires onto a Pi zero board
It's the simplest and most practical route, and should give you 3-4m range. Oskar is going to spend some time formalising this for people soon.
Recommended when:
- You have already bought a Rileylink and don't really want to buy extra things
- You want the best possible range