Main thermostat is not turned off when TRV reaches set temp

[samtate]

Hi @nielsfaber thanks for the great integration. It seems to fit my use case perfectly, however I cannot get the main thermostat to turn off when my TRV reaches a set temp.
I can set my TRV to 1 degree more than its current temperature and it will correctly set the main thermostat to 1 degree more than its current temperature. However, when the TRV reaches the set temp, the TRV turns off but the main thermostat does nothing. The main thermostat just stays heating until it reaches its new set temperature, which is too hot. I currently only have one TRV linked to the integration.

On the switch entity, the previous temperature is unavailable. Is that intended?

There are also a number of errors in the logs regarding zoned-heating. Would you like to see these?

Thanks

[samtate]

screen-20231106-195639.2.mp4

I took a video here of the issue. You can see when I increase heat demand on the TRV (living Room), the main thermostat (hall) increases as I'd expect.

However when I decrease the demand on the TRV, including setting the target temperature below the current temperature, the main thermostat temperature never falls again.

[stinobook]

On the switch entity, the previous temperature is unavailable. Is that intended?

This is indeed not intended when it is in use. however your current state is set to false. can you check what it says when the override is active? so set the TRV temp to a higher temp so the integration does its work.

Can you show me your entity for climate.hall from the developer tab like this:

what thermostat is it ?

the zoned heating switch should look like this (when active only of course)

[nielsfaber]

@samtate Could you keep an eye on the stored controller state / stored controller setpoint ?
The integration is supposed to set your controller (thermostat) to the values here, after the zones have reached their temperature.
From your screenshot i see 'unknown' is stored, which indicates there is no history of what the controller settings were before the integration took over.