Skip to content

2D and 3D Tools

Jump to bottom
cefiar edited this page Jul 14, 2025 · 37 revisions

Laser cutters, 3D printers and associated equipment at the space.

Laser cutter and other CNC

K40 Whisperer (40w)

Status: ✅ OPERATIONAL

Caution

DO NOT adjust the laser power (current) knob, as this will shorten the life of the laser tube.

Usage

Important

Make sure the exhaust fan is running when performing any cutting.

Software is installed on the PC next to the laser cutter.

Bed geometry

Max material size is 359mm x 227mm. Max cut size is 316mm x 216mm. x=0 is 26mm from left., y=0 is 2-3mm outside the material area.

Material

Recommended to use Laser Ply or Acrylic

For cutting, max thickness is 4mm. Will require multiple passes.

Resources

3D Printers

Creality CR-10S Pro V2

Status
✅ OPERATIONAL
Nozzle
0.4mm
Print volume
300x300x400mm
Cura profile
Creality CR-10S Pro

Intermediate (Recommended)

  • Under Support (when enabled) change the default Support Overhang Angle to 46°. This will stop Cura generating supports for 45 degree fillets and edges. The printer should be able to do 50° overhangs with 0.2mm layer heights, if not larger (actual value depends on layer height to layer width ratio).
  • Under Build Plate Adhesion, if using Skirt, change Skirt Height to 1. ** The skirt prints first 10mm beyond the edge of the print. This will allow you to see if the plastic is adhering to the bed properly before the first layer of your object(s) start printing.

(Advanced)

G28 ;Home
G29 ;Auto bed Level
M500 ; save mesh to eeprom
M420 S1 ;Save and use mesh

Resources

Voxelabs Aquilla X2

Important

Printer uses Cura profile with bed reduced to 220x220x250mm

Status
✅ OPERATIONAL
Nozzle
0.4mm
Filament
1.75mm PLA
Print volume
220x220x250mm
Cura profile
Creality Ender-3/Ender-3 v2

No enclosure. Has been upgraded with a magnetic build plate, and bed springs replaced by rubber mounts.
Cura on the PC next to the laser cutter has been set up with a suitable profile.

Resources

Cocoon Create ModelMaker

Status: ✅ OPERATIONAL

Nozzle: 0.4mm. Filament: 1.75mm PLA. Print volume of 120 x 135 x 100mm. No enclosure. Magnetic build plate.
Cura on the PC next to the laser cutter has been set up with a suitable profile.

Resources

Lulzbot Taz 5

Status: ❌ NOT OPERATIONAL

Resources

Currently not operational (needs tuning and a general service, plus construction of an enclosure).
Nozzle: 0.5mm. Filament: 3mm PLA/ABS. Print volume of 298 x 275 x 250mm. No enclosure (currently). PEI build plate.
Cura on the PC next to the laser cutter has been set up with a suitable profile.

Cocoon Create 3D Pen

Nozzle: 0.7mm. Filament: 1.75mm PLA/ABS. Hand-held operation.

Resources

Sunbeam VAC440 FoodSaver Vacuum packaging system

Used for sealing filament up with desiccant after drying so it stays dry. 28mm and 22mm wide plastic continuous pouch material available.

Resources

Clone this wiki locally