startup_x86.s

;; Several sources use this code, I believe it originally came from:
;; http://www.osdever.net/tutorials/view/brans-kernel-development-tutorial

; This is the kernel's entry point. We could either call main here,
; or we can use this to setup the stack or other nice stuff, like
; perhaps setting up the GDT and segments. Please note that interrupts
; are disabled at this point.
[BITS 32]
global _start
_start:
    mov esp, _sys_stack     ; This points the stack to our new stack area
    jmp stublet

; This part MUST be 4byte aligned, so we solve that issue using 'ALIGN 4'
ALIGN 4
mboot:
    ; Multiboot macros to make a few lines later more readable
    MULTIBOOT_PAGE_ALIGN	equ 1<<0
    MULTIBOOT_MEMORY_INFO	equ 1<<1
    MULTIBOOT_HEADER_MAGIC	equ 0x1BADB002
    MULTIBOOT_HEADER_FLAGS	equ MULTIBOOT_PAGE_ALIGN | MULTIBOOT_MEMORY_INFO
    MULTIBOOT_CHECKSUM	equ -(MULTIBOOT_HEADER_MAGIC + MULTIBOOT_HEADER_FLAGS)

    ; This is the GRUB Multiboot header. A boot signature
    dd MULTIBOOT_HEADER_MAGIC
    dd MULTIBOOT_HEADER_FLAGS
    dd MULTIBOOT_CHECKSUM

; A call to main (the C kernel) followed by an infinite loop (jmp $)
stublet:
    EXTERN c_entry 		; start of our kernel
    call c_entry
    jmp $

; Here is the definition of our BSS section. Right now, we'll use
; it just to store the stack. Remember that a stack actually grows
; downwards, so we declare the size of the data before declaring
; the identifier '_sys_stack'
SECTION .bss
    resb 8192               ; This reserves 8KBytes of memory here
_sys_stack: