Wemos D1 Mini problem with Deauth

[vin86]

Hi, i have follow guide on https://github.com/SequoiaSan/FlipperZero-Wifi-ESP8266-Deauther-Module and create a board with Wemos. Unfortunately when i use flipper zero with Deauther App, i can only use attack Beacon and Probe; Deauth attack doesn't work. If i select ap or stations and click on attack, numbers on the left remain stationary.

If i use kali linux with command aireplay-ng, i can use deauth attack on my Network. Which can be problem with Flipper Zero?

[kritonpc]

Same here with a HW-628 v1.1 flashed as wemos d1 mini

[vhristenco]

Try to flash the D1 Mini from the Arduino IDE, making sure you select the correct board (you must select the D1 Mini from the Deauther boards, and not the generic ESP8266 D1). Also change the board type in A_config.h to WEMOS_D1_MINI.
This worked for me.

[kritonpc]

Try to flash the D1 Mini from the Arduino IDE, making sure you select the correct board (you must select the D1 Mini from the Deauther boards, and not the generic ESP8266 D1). Also change the board type in A_config.h to WEMOS_D1_MINI. This worked for me.

I tried this with my board, which is usually flashed as a NodeMCU and it didn't work. I changed the board to both NodeMCU and wemos d1 mini, but it still didn't deauth neither stations nor APs. Any ideas?

[rgeraskin]

I had the same issue with NodeMCU (not Wemos). Resolved by flashing it from the Arduino IDE with commented DEFAULT_ESP8266 and uncommented NODEMCU in A_config.h. Thanks @vhristenco !

// #define DEFAULT_ESP8266

#define NODEMCU

But not sure that commenting was necessary through 🙂