FanControl does not use the fan settings at the start of Windows

[laszlo-pl]

Hi,

Why can my FanControl not use a set profile for the CPU fan immediately after the system starts?

It seems that it loads the set curve and sets the speed to the desired 35%. Despite this, the fan revolves full speed.

Only when I take steps as in the movie below it is all as it should be:

Nagrywanie.2025-02-02.112950.mp4

My specs:

• Gigabyte GA-990XA-UD3
• AMD FX8350
• Arctic P12 Max (ACFAN00280A)

[Rem0o]

That's because the % never changed. You fan initially says 35% @ 1800 RPM. It is at its desired %, so FanControl does nothing. Now when you force a change, it actually goes down to 1000 rpm, but still at 35%. How can FanControl know ?

[laszlo-pl]

So what should I change to make it good?

[Rem0o]

I would try a different % than 35 if that is just some default value which creates this issue. Otherwise I would probably shift my graph in RPM mode from its 3dot menu.