Hi OC Team,
Firstly - Thanks so much for all the excellent open source work you do. It is so very much appreciated and it feels very good to be part of this community.
Issue:
When printing with a filament change (done as filament change at a particular layer in the Preview tab in Elegoo Slicer with the M600 code in the g-code settings for filament change), the CC automatically pauses and removes the old filament as expected. When inserting the new filament and clicking "Load filament" on the keypad, it goes through its loading filament sequence. Sporadically, it doesn't actually heat up and stays at the lower temperature. The solution for this is to go back to the settings in the 3D printer and manually change the nozzle temperature to the printing temperature after which it loads the filament.
I've had this issue twice. Once it didn't heat up at all, and once while heating up half way, it defaulted back to the lower temperature.
Perhaps this could be a timeout thing while in pause??
Thank you!
Hi OC Team,
Firstly - Thanks so much for all the excellent open source work you do. It is so very much appreciated and it feels very good to be part of this community.
Issue:
When printing with a filament change (done as filament change at a particular layer in the Preview tab in Elegoo Slicer with the M600 code in the g-code settings for filament change), the CC automatically pauses and removes the old filament as expected. When inserting the new filament and clicking "Load filament" on the keypad, it goes through its loading filament sequence. Sporadically, it doesn't actually heat up and stays at the lower temperature. The solution for this is to go back to the settings in the 3D printer and manually change the nozzle temperature to the printing temperature after which it loads the filament.
I've had this issue twice. Once it didn't heat up at all, and once while heating up half way, it defaulted back to the lower temperature.
Perhaps this could be a timeout thing while in pause??
Thank you!