README.md

Esp32-Cam-PIR-Telegram

Security-Camera with Esp32 Cam, PIR and Telegram Bot with a beautiful ReplyKeyboard.

Introduction

This is a Telegram bot for the ESP32-CAM that allows you to control your board from anywhere to request a photo, sensor readings or control the flash. Additionally, you’ll receive a notification with a new photo whenever motion is detected.

Components

• ESP32 cam
• PIR Sensor
• Cables
• Eprom Programmer (FT232RL)

Connection schema - For Programming in Arduino IDE

Connection schema - For common use

Available Telegram Commands

• 📷Photo📷: Capture a photo with/without flash based on "📷Flash ON💡" or "📷Flash OFF📵"
• 📷Flash ON💡: Enable flash foro photos
• 📷Flash OFF📵: Disable flash for photos
• 🚨Arm🔥: Enable motion detection
• 🚨Disarm📵: Disable motion detection
• 💡LedON🔥: Enable flash (can be used as a night light)
• 💡LedOFF📵: Diable flash
• 💡AutoFlash🤖: If enabled, the flash will be used for every photo in the time slot from 8pm to 6am.

Still to be implemented:

• Beautiful keyboard with emoji
• Video recordings based on motion and Telegram command
• Save photo/video on micro-sd card
• SSH communication protocol to save photo in secondary network storage