wired midi connection

[jazzzynaps]

hi. this is remarkable work and thank you thank you thank you.
so i need a help but i had to say i have zero knowledge about electronic engineering. :) i did half of work to watch youtube. ( thank you Alcimar Ramos)
i have waveshare zero board and like i sad before i did all connection except wired midi connection. i couldn't find adafruit one. i found this one.(im gonna share picture below this message) but unfortunately i couldnt find any information or video about how can it be connect to waveshare zero and this midi board.
if is not a problem for you can you explain to me how to connect 2 units please.
regards

[Sundeeprk93]

I think if you have any idea about TRS midi, it is way easier for connections - just 3 wires tom your zero board to a trs (either 3.5mm or 6.35mm) female port.

if you want to connect to a midi controller with 5 pin midi port, just buy an trs to 5-pin din midi cable. But make sure it is type A.

[Sundeeprk93]

Refer below image from a different discussion for details on connections.

[jazzzynaps]

thank you for your answer.
i know trs midi but i cant find everything in my country. i stuck this two i am afraid.
so you saying adafruit and my midi board connection to zero is same? am i right?

[Builty]

About that green Midi board above, I tried to make it work myself, but it has some really weird grounding issue that cost me a lot of time. It was also quite poorly made, and the switch was full of dust and didn't work until I cleaned it out.

There are no schematics available to help work out what is the issue.

In the end I gave up on it. Sorry but its not supported.

[jazzzynaps]

thank you so much for your answer. and thank you very very much for all your fantastic work.
regards